Water Sample Filter Core

Product introduction

Wire-wound filter element is installed in the filter. The size of the filter element is relatively small. It is used to filter the water sample of the instrument and protect the instrument electrode.

1. The shell is made of plexiglass.

2. When replacing the filter element, the lower end cap should be unscrewed.

3. Install check valve at outlet of water sample filter to prevent instrument electrode from losing water

4. Connection mode: threaded connection

Technical parameter

1. Nominal Pressure:<0.8Mpa

2. Experimental pressure: 1.0 Mpa

3. Applicable medium: instrument sample water

4. Applicable Temperature:<60 Temperature

5. Maximum flow: 2000ml/min

Performance characteristics

1. High filtration accuracy, small pressure difference, large flow rate, long service life of pollution acceptance ambassador;

2. Polypropylene degreased cotton wire-wound filter element can be used for the filtration of non-organic solutions such as acids and alkalis, chemical solutions and so on, using temperature < 60 degrees.

3. Stainless steel material in the center rod of degreased cotton fiber filter element is used for organic solvents, water, oil, alkaline solution, beverage, medicine and so on, and the use temperature is less than 120.

4. Maximum withstand voltage:<0.4MPa, maximum pressure drop: 0.2MPa

Warm Tip: The filter element needs to be replaced regularly. To maintain the normal operation of the protection system.

Wire-wound filter element is installed in the filter, the size of the filter element is relatively small. It is used to filter the water sample of the instrument and protect the electrode of the instrument.